Search
Filters
Close

WF57-320240QD#B07-FC

TFT 5.7'' 320x240, LCD + IC Controller, Interface MCU (Parallel) IC SSD1963 (8/16bit), 400cd/m², Frame, Capacitive touch panel I2C interface (GG, ILI2130 IC)

DESCRIPTION

New TFT+CTP Ilitek IC ILI2130 version // Previous TFT+CTP Focaltech IC FT5426 version P/N WF57-320240QD#A07-FC in 'Related Product' section on the bottom page

5.7 inch diagonal size of Winstar TFT Q series family.  TFT 320x240 Display with SSD1963 controller board plus a 36 pin-out connector on board. This model is featured with 8 bit or 16 bit options and already defined pin no. 33 ~ 36 as backlight supply; therefore, there is no need to design extra backlight circuit. Module dimension 141.12 x 101.55 mm. Projected Capacitive Touch Panel (PCAP) on module.

 

DRAWING

 

 

SPECIFICATIONS

Interface

PinSymbolFunction
1 GND System ground pin of the IC . Connect to system ground.
2 VDD Power Supply : +3.3V
3 BLE Backlight control signal , H: On \ L: Off
4 D/C Data/Command select
5 WR Write strobe signal
6 RD Read strobe signal
7~14 DB0~DB7 Data bus
15~22 DB8~DB15 Data bus (When select 8bits Mode, this pin is NC)
23 NC No connect
24 CTP_INT CTP_ External interrupt to the host
25 CS Chip select
26 RESET Hardware reset
27 L/R Left / right selection; Default L/R=H
28 U/D Up/down selection; ; Default U/D=L
29 CTP_SCL CTP_SPI Slave mode, chip select, active low / I2C clock input
30 CTP_SDA CTP_ SPI Slave mode, data input / I2C data input and output
31 CTP_RST CTP_ External Reset, Low is active
32 NC No connect
33~34 VLED- Power for LED Driver IC(GND)
35~36 VLED+ Power for LED Driver IC(+5V)

 

General Specifications

ItemDimensionUnit
Size 5.7 inch
Dot Matrix 320 × RGB × 240(TFT) dots
Module dimension 141.12 × 101.55 × 15.24 mm
Active area 115.2 × 86.4 mm
Dot pitch 0.12 × 0.36 mm
LCD type TFT, Normally White, Transmissive
View Direction 12 o'clock
Gray Scale Inversion Direction 6 o'clock
Aspect Ratio 4:3
Backlight Type LED, Normally White
Controller IC SSD1963 or Equivalent
TFT Interface Digital 8080 family MPU  8bit/16bit
PCAP FW Version 0x07.0x00.0x00.0x00.0xA1.0x01.0x57.0x00
PCAP IC ILI2130 or equivalent
PCAP Interface I2C
PCAP Resolution 16384*16384
Touch Panel Projected capacitive touch panel (PCAP)
Surface Glare

 

Absolute Maximum Ratings

ItemSymbolMinTypMaxUnit
Operating Temperature TOP -20 +70
Storage Temperature TST -30 +80

 

Electrical Characteristics

ItemSymbolConditionMinTypMaxUnit
Supply Voltage For LCM VDD 3.0 3.1 3.3 V
Supply Current For LCM IDD 469 705 mA


 

SKU: WF57-320240QD#B07-FC
Brand: Winstar
Available: No
Accessory Kit
Price Breaks
Quantity
1+
5+
10+
Price
€116.90
€114.90
€98.80

For quantities above 25 pcs pls send your enquiry to sales@first-components.com or call +39 0332 1888005

€116.90 excl tax

DESCRIPTION

New TFT+CTP Ilitek IC ILI2130 version // Previous TFT+CTP Focaltech IC FT5426 version P/N WF57-320240QD#A07-FC in 'Related Product' section on the bottom page

5.7 inch diagonal size of Winstar TFT Q series family.  TFT 320x240 Display with SSD1963 controller board plus a 36 pin-out connector on board. This model is featured with 8 bit or 16 bit options and already defined pin no. 33 ~ 36 as backlight supply; therefore, there is no need to design extra backlight circuit. Module dimension 141.12 x 101.55 mm. Projected Capacitive Touch Panel (PCAP) on module.

 

DRAWING

 

 

SPECIFICATIONS

Interface

PinSymbolFunction
1 GND System ground pin of the IC . Connect to system ground.
2 VDD Power Supply : +3.3V
3 BLE Backlight control signal , H: On \ L: Off
4 D/C Data/Command select
5 WR Write strobe signal
6 RD Read strobe signal
7~14 DB0~DB7 Data bus
15~22 DB8~DB15 Data bus (When select 8bits Mode, this pin is NC)
23 NC No connect
24 CTP_INT CTP_ External interrupt to the host
25 CS Chip select
26 RESET Hardware reset
27 L/R Left / right selection; Default L/R=H
28 U/D Up/down selection; ; Default U/D=L
29 CTP_SCL CTP_SPI Slave mode, chip select, active low / I2C clock input
30 CTP_SDA CTP_ SPI Slave mode, data input / I2C data input and output
31 CTP_RST CTP_ External Reset, Low is active
32 NC No connect
33~34 VLED- Power for LED Driver IC(GND)
35~36 VLED+ Power for LED Driver IC(+5V)

 

General Specifications

ItemDimensionUnit
Size 5.7 inch
Dot Matrix 320 × RGB × 240(TFT) dots
Module dimension 141.12 × 101.55 × 15.24 mm
Active area 115.2 × 86.4 mm
Dot pitch 0.12 × 0.36 mm
LCD type TFT, Normally White, Transmissive
View Direction 12 o'clock
Gray Scale Inversion Direction 6 o'clock
Aspect Ratio 4:3
Backlight Type LED, Normally White
Controller IC SSD1963 or Equivalent
TFT Interface Digital 8080 family MPU  8bit/16bit
PCAP FW Version 0x07.0x00.0x00.0x00.0xA1.0x01.0x57.0x00
PCAP IC ILI2130 or equivalent
PCAP Interface I2C
PCAP Resolution 16384*16384
Touch Panel Projected capacitive touch panel (PCAP)
Surface Glare

 

Absolute Maximum Ratings

ItemSymbolMinTypMaxUnit
Operating Temperature TOP -20 +70
Storage Temperature TST -30 +80

 

Electrical Characteristics

ItemSymbolConditionMinTypMaxUnit
Supply Voltage For LCM VDD 3.0 3.1 3.3 V
Supply Current For LCM IDD 469 705 mA


 

Products specifications
Brand Winstar
Size 5.7"
Resolution 320x240
Active Area (mm) 115.20x86.40
Color Full Color
Display Interface MCU (Parallel)
Display IC SSD1963
View Angle TN
Frame Yes
Touch Panel Capacitive
O. Temperature (°C) -20~70
Display Connection ZIF Connector
Pin Nr. 36
Pin Pitch 0.5mm
Touch Panel IC Controller ILI2130
Preferred - Not Preferred Preferred
Download
Products specifications
Brand Winstar
Size 5.7"
Resolution 320x240
Active Area (mm) 115.20x86.40
Color Full Color
Display Interface MCU (Parallel)
Display IC SSD1963
View Angle TN
Frame Yes
Touch Panel Capacitive
O. Temperature (°C) -20~70
Display Connection ZIF Connector
Pin Nr. 36
Pin Pitch 0.5mm
Touch Panel IC Controller ILI2130
Preferred - Not Preferred Preferred
Recently viewed
;